Threaded Mode | Linear Mode

wappinghigh · (This post was last modified: 28-07-2013 07:08 by wappinghigh.)

Hi everyone.

Has anybody put this new major firmware upgrade on their QNAP's yet?

Any problems with MinimServer?

I'm running an ARM QNAP the 119P

Thanks Smile

Oroperplex · (This post was last modified: 28-07-2013 08:23 by Oroperplex.)

(28-07-2013 07:08)wappinghigh Wrote: Hi everyone.

Has anybody put this new major firmware upgrade on their QNAP's yet?

Any problems with MinimServer?

I'm running an ARM QNAP the 119P

Thanks

I have a TS119 and had no issues with 4.01 nor 4.02 installed in the morning

wappinghigh · (This post was last modified: 28-07-2013 10:49 by wappinghigh.)

Great. Went through beautifully. Used Qnap finder.... Nice one. No special steps either. Thanks!

wappinghigh · 28-07-2013, 09:48

Simon? Have you done it yet? Smile

simoncn · 28-07-2013, 23:00

(28-07-2013 09:48)wappinghigh Wrote: Simon? Have you done it yet?

Not yet, mainly because I don't see any benefits compared with being on 3.7.3. Are there any?

I'm pleased to hear that MinimServer is working OK with 4.0x.

dariusb · 02-09-2013, 12:38

(28-07-2013 23:00)simoncn Wrote:
(28-07-2013 09:48)wappinghigh Wrote: Simon? Have you done it yet?

Not yet, mainly because I don't see any benefits compared with being on 3.7.3. Are there any?

I'm pleased to hear that MinimServer is working OK with 4.0x.

Hello,

I have 4.0.2 on my Qnap TS119. Minim 0.72 works good, but... when transcoding feature is switched-on cpu utilization is ~98%.
I'm not sure about firmware version installed before the upgrade, but I'm sure 100% that cpu worked at about ~50% utilization.

I have no active/enabled apps on my qnap apart twonky.

Regards,
Darius

simoncn · 02-09-2013, 18:29

(02-09-2013 12:38)dariusb Wrote: Hello,

I have 4.0.2 on my Qnap TS119. Minim 0.72 works good, but... when transcoding feature is switched-on cpu utilization is ~98%.
I'm not sure about firmware version installed before the upgrade, but I'm sure 100% that cpu worked at about ~50% utilization.

I have no active/enabled apps on my qnap apart twonky.

Regards,
Darius

The additional CPU usage is probably caused by the QNAP Media Library service scanning your media files. You can wait for this scanning to finish (which might take days or even weeks) or you can disable the Media Library service.