+- MinimServer Forum (https://forum.minimserver.com)
+-- Forum: MinimServer (/forumdisplay.php?fid=1)
+--- Forum: General (/forumdisplay.php?fid=2)
+--- Thread: QNAP new 4.0 Firmware. Problems? (/showthread.php?tid=712)
QNAP new 4.0 Firmware. Problems? - wappinghigh - 28-07-2013 07:08
Hi everyone.
Has anybody put this new major firmware upgrade on their QNAP's yet?
Any problems with MinimServer?
I'm running an ARM QNAP the 119P
Thanks
RE: QNAP new 4.0 Firmware. Problems? - Oroperplex - 28-07-2013 08:23
(28-07-2013 07:08)wappinghigh Wrote: Hi everyone.
Has anybody put this new major firmware upgrade on their QNAP's yet?
Any problems with MinimServer?
I'm running an ARM QNAP the 119P
Thanks
I have a TS119 and had no issues with 4.01 nor 4.02 installed in the morning
RE: QNAP new 4.0 Firmware. Problems? - wappinghigh - 28-07-2013 09:30
Great. Went through beautifully. Used Qnap finder.... Nice one. No special steps either. Thanks!
RE: QNAP new 4.0 Firmware. Problems? - wappinghigh - 28-07-2013 09:48
Simon? Have you done it yet?
RE: QNAP new 4.0 Firmware. Problems? - simoncn - 28-07-2013 23:00
(28-07-2013 09:48)wappinghigh Wrote: Simon? Have you done it yet?
Not yet, mainly because I don't see any benefits compared with being on 3.7.3. Are there any?
I'm pleased to hear that MinimServer is working OK with 4.0x.
RE: QNAP new 4.0 Firmware. Problems? - dariusb - 02-09-2013 12:38
(28-07-2013 23:00)simoncn Wrote:(28-07-2013 09:48)wappinghigh Wrote: Simon? Have you done it yet?
Not yet, mainly because I don't see any benefits compared with being on 3.7.3. Are there any?
I'm pleased to hear that MinimServer is working OK with 4.0x.
Hello,
I have 4.0.2 on my Qnap TS119. Minim 0.72 works good, but... when transcoding feature is switched-on cpu utilization is ~98%.
I'm not sure about firmware version installed before the upgrade, but I'm sure 100% that cpu worked at about ~50% utilization.
I have no active/enabled apps on my qnap apart twonky.
Regards,
Darius
RE: QNAP new 4.0 Firmware. Problems? - simoncn - 02-09-2013 18:29
(02-09-2013 12:38)dariusb Wrote: Hello,
I have 4.0.2 on my Qnap TS119. Minim 0.72 works good, but... when transcoding feature is switched-on cpu utilization is ~98%.
I'm not sure about firmware version installed before the upgrade, but I'm sure 100% that cpu worked at about ~50% utilization.
I have no active/enabled apps on my qnap apart twonky.
Regards,
Darius
The additional CPU usage is probably caused by the QNAP Media Library service scanning your media files. You can wait for this scanning to finish (which might take days or even weeks) or you can disable the Media Library service.