Threaded Mode | Linear Mode

adriaan · 23-12-2021, 21:24

I played a complete album and attached is the log... Not sure the Java IO errors are also present here as the logging is quite different with Debug level...

simoncn · (This post was last modified: 24-12-2021 10:17 by simoncn.)

This log doesn't show any errors. Without a log that shows one of these errors, I am unable to identify the cause of the problem.

If you see this again, please capture a debug log. A log from playing a single file is all I need.

Edit: I have looked at the log again and the renderer is behaving quite strangely, starting to stream a file, then aborting the connection after a short time, then starting the same file again, with all this repeated many times. This is likely to be the reason for the "stream closed" messages from the FLAC decoder. Which renderer are you using?

adriaan · 24-12-2021, 11:12

Some more info:
- To control my music I am using Mconnect (upnp based).
- My music streamer is the sotm sms 200 Ultra Neo.
- In between my audio pc (running minimstreamer) is also a switch.

stefano_mbp · (This post was last modified: 24-12-2021 12:50 by stefano_mbp.)

For first I would try to remove/change the switch.
Which eunhasu version are you running on the SOtM? the last one is 0.5.2
If not on this version try to update, here you can find the link (bottom of the page)
https://docs.sotm-audio.com/doku.php?id=...card_image
It’s better to burn a new image instead of the OTA update as it is veeery long, around three hours

stefano_mbp · (This post was last modified: 24-12-2021 12:12 by stefano_mbp.)

… here I’m running a very similar setup with a SOtM sms200 Neo (not Ultra) and don’t have any issue

simoncn · 24-12-2021, 12:17

(24-12-2021 12:12)stefano_mbp Wrote: … here I’m running a very similar setup with a SOtM sms200 Neo (not Ultra) and don’t have any issue

Do you use flac:wav transcoding (no semicolon)?

simoncn · 24-12-2021, 12:19

(24-12-2021 12:10)stefano_mbp Wrote: For first I would try to remove the switch.

How can MinimServer/MinimStreamer be connected to a renderer without using a switch? Perhaps I have misunderstood the setup.

stefano_mbp · 24-12-2021, 12:20

No, but I can try it in few minutes and report back here

stefano_mbp · 24-12-2021, 12:29

… remove/change the switch …
Just tried playing from Minimserver/flac:wav (no semicolon)/MConnect Player HD/SOtM sMS200-MPD V0.5.2 and it works without issues

adriaan · (This post was last modified: 24-12-2021 12:51 by adriaan.)

Q. How can MinimServer/MinimStreamer be connected to a renderer without using a switch? Perhaps I have misunderstood the setup.
A. I am using a switch. The data stream is music pc with minimstreamer > switch > sotm sms 200 Ultra Neo > DAC

Q. Do you use flac:wav transcoding (no semicolon)?
A. Steam.transcode setting = flac:wav, dsf:dopwav

Next week I will receive a new high end sotm switch, maybe they problem is related to the switch...