MinimServer stopped working on QNAP

[daedlo]

(12-12-2017 10:59)daedlo Wrote:  

(12-12-2017 06:49)simoncn Wrote:  

(11-12-2017 21:02)leighton buzzard Wrote:  Just updated Minimserver on my QNAP and now it wont run. MinimWatch log is showing the following message...

[MinimServer] is running
Error 1 [Unknown] invoking GetAllPackageStatus on remote runtime monitor
Error 1 [Unknown] invoking GetProperty on remote runtime monitor
Error 1 [Unknown] invoking GetProperty on remote runtime monitor

(11-12-2017 22:00)daedlo Wrote:  I have the same problem.
MinimServer did auto update to 112 this morning and since then am unable to access. I have tried via Linn Kazoo on iPad as well as MinimWatch on iMac and Win10 pc.
I have re-installed MinimServer on the QNAP NAS I use for my music files with no difference. I have switched NAS off/on with no difference. The only indication I get is the error message in MinimWatch:
Error 1 [Unknown] invoking GetProperty on remote runtime monitor

When the problem is occurring, is the MinimServer status web page working? You can check this by going to http://x.x.x.x:9790 in a web browser, where x.x.x.x is the IP address of the NAS.

In my case I am using a TS212 NAS. I am unable to access the MinimServer web page with Safari. There is a short time after my initial start of MinimWatch when the status is green. However, on trying to access the server it goes to grey and only the bottom three options are available.

sorry didn't notice new update to try. Reloaded MinimServer on NAS and version 113 loaded. Now everything seems to be working as it should. Many thanks Simon.

[Peter StreamMagic]

(12-12-2017 09:16)Peter StreamMagic Wrote:  

(12-12-2017 08:56)simoncn Wrote:  I have been able to reproduce the problem on my QNAP TS-119. It is a caused by a crash in the latest level of ohNet, whcih was included in updates 111 and 112.

I have published update 113 which reverts to a previous level of ohNet that is known to work OK. If you have autoUpdate set to true, update 113 will install automatically when you do the following:

1) In the App Center, select Stop from the drop-down menu of the MinimServer icon

2) Wait for the MinimServer icon to change from green to grey

3) Select Start from the MinimServer icon

I will have a try tonight, some people have to work during the day.

MinimServer is up again.
Many thanks, great support!!

Best regards,
Peter

[leighton buzzard]

Thanks, Simon. Seems to be fine after the update. :-)

[simoncn]

I have just released update 114. This reinstates the current ohNet version (needed to fix other issues) and also includes a fix for the QNAP problem that affected updates 111 and 112. If all goes well, no-one should notice any difference after installing 114.

There has been quite a bit of "update churn" recently, with problems on some platforms and emergency action to correct these. Many thanks for your patience and understanding as we worked through these issues. I hope very much that normal service will be resumed now.