Minimwatch cannot see Minimserver

[simoncn]

(18-07-2014 12:37)rweten Wrote:  Simon

How do I get MinimWatch/MinimServer to work 'seamlessly' on both the wired and wireless network adapters on my PC?

I have been mostly using Kinsky through the Wired Adapter. As we discussed earlier, I set the ohnet.subnet value to 192.168.1.0 to get it listening on my network.

If I disconnect my ethernet cable and try to go wireless, Kinsky will ask me if I want to select a different network adapter, which seems fine. However, when I click 'Yes' to select one, it won't offer a list for me!

This is a bug in Kinsky. After clicking Yes, you need to do right-click (in the top section) > Tools > Options > Network > Network Interface and select the correct adapter.

Quote:Ideally I would want MinimWatch/MinimServer to be able to auto-select whether I'm on the Wired or Wireless networks (the two different adapters have IP addresses fixed in the router btw), or to allow me to manually switch when I change networks. At the moment the only way I've found is to uninstall Kinsky and then reinstall it, which is a bit painful.

The two network adapters do use the same subnet, by the way.

Richard

MinimWatch will switch between these adapters automatically if they are on the same subnet. Unfortunately, Kinsky requires manual switching.