Qnap TS220 installation problem

[QTEC]

(27-03-2014 23:08)simoncn Wrote:  

(27-03-2014 19:57)QTEC Wrote:  I have recently purchased QNAP TS 220 to work with Naim NDX.
I have read many favourable reports on the Naim forum about Minimserver and decided to try it.
Everything appeared to be ok with the installation until the Minimserver application was enabled, after about 10 seconds it was disabled with the following message in the system log :-minimserver start error: /share/MDO_DATA/.qpkg/minimserver.sh:line 84/usr/local/jre/bin/java: No such file or directory.

I disabled and re-enabled minimserver and then restarted the nas as suggested but the problem remained.

Any suggestions/ advice would be appreciated.

You need to install Java on the NAS before installing MinimServer. For detailed instructions, see this page. You should uninstall MinimServer before you install Java. After you have successfully installed Java, install MinimServer again and MinimServer should start without producing an error message.

Thanks for your prompt response.
I did follow your installation guide for QNAP NAS.
I copied the java file to the public share file in the tar.gz format.
The file size is 32mb.
I installed the JRE_7qpkg and enabled it in the QNAP admin console.
I then installed the minimserver qpkg and enabled it.
I then got the above error message.
It appears that the JRE7 is not unpacking the tar.gz file in the public folder.