Set up MiminServer on QNAP

[simoncn]

(21-12-2024 09:39)Peter@57m Wrote:  So try doing a minimserver rescan and leave it for a while to make sure its finished. Then do a Lumin Library reload. Hopefully this may sort most of the problems.

If you are using the MinimServer configuration web page to do a rescan, the status on that page changes from Rescanning to Running when the scan is complete.

Quote:Something else to check is the minimserver log. You can do this using minimwatch. This will show any issues that minimserver is finding with your files that are preventing them from being indexed.

If you don't have MinimWatch running, you can view the MinimServer log by looking at the minimserver.log file in the MinimServer/data shared folder. In the log, a message starting with "Warning" means the file was read and added to the MinimServer library even though it had some errors. A message starting with "Error" means the file was not added to the MinimServer library because it had an unrecoverable severe error.

You should start by doing this before you make change any changes to your files with a tagging program.