QNAP new 4.0 Firmware. Problems?

[simoncn]

(02-09-2013 12:38)dariusb Wrote:  Hello,

I have 4.0.2 on my Qnap TS119. Minim 0.72 works good, but... when transcoding feature is switched-on cpu utilization is ~98%.
I'm not sure about firmware version installed before the upgrade, but I'm sure 100% that cpu worked at about ~50% utilization.

I have no active/enabled apps on my qnap apart twonky.

Regards,
Darius

The additional CPU usage is probably caused by the QNAP Media Library service scanning your media files. You can wait for this scanning to finish (which might take days or even weeks) or you can disable the Media Library service.