Cannot install Minimserver after rolling back to Melco firmware v3.80

[simoncn]

I have tried this with 3.80 and MinimServer 0.8.5.4 is installing successfully. Before doing this, I ran Initialize Settings on 3.80.

The message you are seeing would be produced if you are trying to restore settings from a MinimServer 0.8.5.4 flash drive on a firmware version older than 3.80.

Removing MinimServer, initializing the Melco settings or downgrading the firmware uninstalls MinimServer and leaves the MinimServer files on the hard drive. This is intentional and should not cause any problem when reinstalling MinimServer.