Post Reply 
MinimServer stopped working on QNAP
12-12-2017, 10:59
Post: #20
RE: MinimServer stopped working on QNAP
(12-12-2017 06:49)simoncn Wrote:  
(11-12-2017 21:02)leighton buzzard Wrote:  Just updated Minimserver on my QNAP and now it wont run. MinimWatch log is showing the following message...

[MinimServer] is running
Error 1 [Unknown] invoking GetAllPackageStatus on remote runtime monitor
Error 1 [Unknown] invoking GetProperty on remote runtime monitor
Error 1 [Unknown] invoking GetProperty on remote runtime monitor

(11-12-2017 22:00)daedlo Wrote:  I have the same problem.
MinimServer did auto update to 112 this morning and since then am unable to access. I have tried via Linn Kazoo on iPad as well as MinimWatch on iMac and Win10 pc.
I have re-installed MinimServer on the QNAP NAS I use for my music files with no difference. I have switched NAS off/on with no difference. The only indication I get is the error message in MinimWatch:
Error 1 [Unknown] invoking GetProperty on remote runtime monitor

When the problem is occurring, is the MinimServer status web page working? You can check this by going to http://x.x.x.x:9790 in a web browser, where x.x.x.x is the IP address of the NAS.

In my case I am using a TS212 NAS. I am unable to access the MinimServer web page with Safari. There is a short time after my initial start of MinimWatch when the status is green. However, on trying to access the server it goes to grey and only the bottom three options are available.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: MinimServer stopped working on QNAP - daedlo - 12-12-2017 10:59

Forum Jump:


User(s) browsing this thread: 1 Guest(s)