Trouble Installing MinimServer on Melco N1ZH

[GreenMtnGringo]

Hi Simon. I reformatted my USB flash drive from exFAT to FAT16. Despite getting what I suspect is the desired EJECT message (see below) I ended up with the same SHARE folder log file that I posted above.

At this point, I think I should find and try a different USB flash drive.

*****

Last login: Tue Dec 27 19:59:32 on console
XXXXXXXX-MacBook-Pro:~ XXXXXX$ /Volumes/MinimServer-0.8.4.4-melco/create-installer ; exit;

This utility writes the MinimServer installer image for the Melco N1 to
a USB flash drive. For this, you need to have a USB flash drive of 128 MB
or larger attached to this machine.

Check for available USB drives (y/n)?
y

The following USB drives are available:

Device Identifier: disk1
Device / Media Name: General USB Flash Disk Media
0: FDisk_partition_scheme *1.0 GB disk1
1: DOS_FAT_16 UNTITLED 1.0 GB disk1s1

Enter device identifier of Melco installer flash drive or null line to exit:
disk1

You have selected the following device:

Device Identifier: disk1
Device / Media Name: General USB Flash Disk Media
0: FDisk_partition_scheme *1.0 GB disk1
1: DOS_FAT_16 UNTITLED 1.0 GB disk1s1

All data on this device will be erased. Are you sure (y/n)?
y

Unmounting device disk1....
Unmount of all volumes on disk1 was successful
Writing installer image to device disk1 (this can take a while)....
Password:
XXXXXXXXXXX

122+1 records in
122+1 records out
128000000 bytes transferred in 45.251649 secs (2828626 bytes/sec)
The image was written sucessfully

Completing setup of device disk1....
Ejecting device disk1....
Disk disk1 ejected

The installer flash drive setup has completed successfully

You can now close this window and remove the flash drive.

logout

[Process completed]