Installing on Synology DSM6

[simoncn]

(25-03-2016 23:01)Bart Wrote:  Perhaps this is documented elsewhere but just in case . . .

I was driving myself crazy as I could not get a fresh install to work on my new Synology DS216+

I did the manual install, but the box 'run after install' was checked. MinimServer would install but not run and manually trying to start it did not work.

After a few tries, I did an install with the 'run after install' box NOT checked. It installed fine and when I manually started it, it started! Yay!

Thanks for this information. I'm not sure what could cause this.

Did you get any error message when "manually trying to start it did not work"?

Which version of DSM (5.2 or 6.0) were you using?

Which version of MinimServer (x86 or x64) did you download for the manual install?