update 73

[Martin H]

Simon,

I have just updated minimserver on the servers. QNAP TS421's and a Melco.

All devices are up and running physically and I can access files via windows explorer etc. but not so good with minimserver/minimwatch at the moment. Below is as much detail as I have:

One QNAP bounced back on the new version as usual and without any obvious problem.
The other QNAP is showing as present on minimwatch but stopped and didn't seem to respond to a restart request.
The MELCO itself is accessible but the server isn't showing up on minimwatch at all.
Only the first 'OK' QNAP is showing up as an option in Kazoo.

I have rebooted all of the servers (including the Melco) but this didn't appear to make any difference with each returning to the same state.

I accessed the log of the OK server and the stopped one and nothing of note there. I also managed to access the device page of all them (accessed it on the OK one and just amended the IP address to access each server). All respond with version 73 and as running. Minimwatch is only showing the original OK one.

I then updated the QNAP firmware on the stopped one just in case it might be linked but I would doubt that as the working one hasn't been updated. On restart (it's second) it did eventually show in Kazoo but still isn't showing in minimwatch. I have rebooted the router already.

I am updating the other QNAP now (again without optimism that it is connected). When that is done. I will reboot everything and post again. Not too clear what to try with the Melco.

Back soon.