Control point response

[simoncn]

(07-03-2015 17:54)beckphotonik Wrote:  Since MinimServer update 60 and MinimStreamer 0.5.5 I have had problems with my control point. I can select the first track on switch on then if I close the control point app and re-open it then it fails to re-engage with the streamer or server. Occasionally it may wake up some 10 to 15 minutes later but not always. This problem exists on iPad running the Chord HD app and on Nexus7 running the Chord HD app. Running BubbleUpnp on the nexus does work eventually but it takes about 10 mins to find the renderer then another 5 mins to find MinimServer, after that it appears to work ok. I thought MinimStreamer 0.5.9 sorted it last night but no, I still have the problem.

Your reference to 15 minutes is a big clue to what's causing this. It sounds like a network problem caused by UPnP multicast discovery M-SEARCH messages not being handled correctly by the network. The control point should send these when it's reopened and the server and renderer should respond. It sounds like these messages aren't being received by the server and renderer. The server and renderer are also sending out "alive" multicast announcement messages periodically and the control point is eventually receiving an "alive" message and reestablishing contact.

The first step is to power all your equipment off and on, including all control points, servers, renderers, switches and routers. This might fix the problem. If it doesn't, have you made any changes to anything in your network recently?

There have been no recent changes to network discovery in MinimServer or MinimStreamer.