configuring transcoding

[airflow]

(04-03-2015 16:52)simoncn Wrote:  If this is OK, then the ffmpeg command should be OK as well.

Can you try pasting this command into a command prompt to see if it works:

ffmpeg -v 0 -analyzeduration 0 -f mp3 -request_sample_fmt flt -i "/media/musik/archiv/Erlend Øye [DJ-Kicks_ Erlend Øye]/01 - So weit wie noch nie.mp3" -f s24le -acodec pcm_s24le -sample_fmt s32 pipe:

You will probably need to redirect stdout to a file.

Edit: It might be a good idea to remove -v 0 so that you see any error messages.

What is the platform default charset value shown at the start of the MinimServer log?

I tried your suggestions above. The command seems to work if I copy and paste it just as you quoted it. When I redirect the output into a file, it generates a file (56MB), which I cannot playback with VLC locally when named with a "wav"-extension. I don't know if that should work or not.

When omitting "-v 0", I see some output during transcoding, including an errormessage. I attach the output so you can take a look at it.

Regarding the default charset value - the log-file of MinimServer says the following when being started: "Platform default charset is US-ASCII". I have to say this last bit is catching my attention - perhaps here lies the problem, what do you think? I'll look about how to modify the platform default charset.