Minimserver without internet

[Ooteboe]

Is it possible to use a laptop with Minimserver-2 in an environment without internet? I then use the laptop with a small router that establishes the connection between the tablet with BubbleUPnP and the server-laptop. The router then has no WAN connection. My experience shows that the music is well sent to the tablet, but that I sometimes (not always) have a delay (of about 45 seconds) in starting a file. If I use the same configuration elsewhere with a connection to the WAN port, that delay is never there. Who knows why and how it can be remedied?

Thanks, Hans

[simoncn]

MinimServer does not send any messages over the WAN connection when starting to stream a file. It does check for updates when you first start MinimServer. It is possible that the delay might be caused by your control point or renderer attempting to send a WAN message.

[Ooteboe]

(22-06-2020 10:48)simoncn Wrote:  MinimServer does not send any messages over the WAN connection when starting to stream a file. It does check for updates when you first start MinimServer. It is possible that the delay might be caused by your control point or renderer attempting to send a WAN message.

Thank you for your response. Strange. I once again examined the reason for this delay. Discovered that it doesn't occur with BubbleUPnP on Galaxy Note 9 as CP, but it does with BubbleUPnP on Galaxy TabS6. But only with the TP-Link WR802N. With the TP-Link Archer C2300 V1 there is no delay. I will limit myself to the Note9. Is too complicated what causes it.

Thanks, Hans