(04-03-2015 15:20)simoncn Wrote:  Thanks for the quick response. Are you running this on FreeBSD? I will try running it on Linux to see what happens.

(04-03-2015 15:34)airflow Wrote:  Yes, I run MinimServer on FreeBSD. I find it interesting that in the log-file there is the same filename correctly displayed in one log-message, while in another log-message the same filename is displayed in a malformed way (relativePath looks good, while resourcePath seems garbled). For me with my limited knowledge this points to the direction that internally there might be some problem with handling UTF8-strings?

(04-03-2015 13:32)simoncn Wrote:  

(04-03-2015 12:52)bubbleguuum Wrote:  A possible cause: when transcoding FLAC to mp3, the -vn ffmpeg option must be used to exclude album art (seen by ffmpeg as a mjpeg track) from the transcode as it will the transcode to fail.

The OP is transcoding in the opposite direction (from mp3 to wav). Is there a similar issue if the transcoding input mp3 file contains album art inside an ID3v2 tag?

(04-03-2015 15:59)simoncn Wrote:  Is the artist's name Erlend Øe? If so, both paths are wrong.

(04-03-2015 16:11)airflow Wrote:  No, it's Erlend Øye. relativePath looks OK for me.

(04-03-2015 16:52)simoncn Wrote:  If this is OK, then the ffmpeg command should be OK as well.

Can you try pasting this command into a command prompt to see if it works:

ffmpeg -v 0 -analyzeduration 0 -f mp3 -request_sample_fmt flt -i "/media/musik/archiv/Erlend Øye [DJ-Kicks_ Erlend Øye]/01 - So weit wie noch nie.mp3" -f s24le -acodec pcm_s24le -sample_fmt s32 pipe:

You will probably need to redirect stdout to a file.

Edit: It might be a good idea to remove -v 0 so that you see any error messages.

What is the platform default charset value shown at the start of the MinimServer log?

(04-03-2015 17:56)airflow Wrote:  I tried your suggestions above. The command seems to work if I copy and paste it just as you quoted it. When I redirect the output into a file, it generates a file (56MB), which I cannot playback with VLC locally when named with a "wav"-extension. I don't know if that should work or not.

When omitting "-v 0", I see some output during transcoding, including an errormessage. I attach the output so you can take a look at it.

Quote:Regarding the default charset value - the log-file of MinimServer says the following when being started: "Platform default charset is US-ASCII". I have to say this last bit is catching my attention - perhaps here lies the problem, what do you think? I'll look about how to modify the platform default charset.

(04-03-2015 15:59)bubbleguuum Wrote:  No, but it is a good idea to use -vn (ignore video tracks, such as mjpeg in FLAC) when transcoding audio.

(04-03-2015 18:29)simoncn Wrote:  This US-ASCII setting is definitely the cause of the problem. When MinimServer runs the ffmpeg command, some characters in the command string are getting mangled because of this incorrect setting. To fix it, you need to use the locale and/or localedef commands to set the charset to UTF-8.