Threaded Mode | Linear Mode

Sherwoodforest · 05-11-2021, 17:20

That's the version I'm running on my AS1002T. It's been tried with IGMP snooping both on and off on the router (with a reboot between just in case), and it works fine across two totally different combinations of control point and renderer. IGMP snooping is currently on.

(Cyrus Cadence/Lyric, and Audionet RCP/Yamaha WXAD-10. It was tested briefly RCP/Lyric, and that is OK too).

simoncn · 05-11-2021, 17:35

I left MinimServer running with snooping enabled and it showed up in control points and MinimWatch after a few minutes. With snooping disabled, it shows up immediately.

Sherwoodforest · 05-11-2021, 23:45

TBF, Simon, it might have been slightly less initially responsive with snooping turned on, but not to an extent that is overtly noticeable, and it is certainly no less responsive in subsequent use. (Certainly nothing measurable in minutes).

Maybe it's simply differences in our underlying technology and network topology. (One of my connections is via an unmanaged switch, and the other is wireless).

Whatever, it would appear that, at worst, one simply needs to be patient (and given other reported issues in the migration to ADM4, that's not a bad result).