Changing Hard Drive in a Melco

[Peter@57m]

(21-10-2021 14:02)nfnc Wrote:  

(01-01-2020 23:02)simoncn Wrote:  Yes, that's all. I recommend formatting the new drives as spanned.

Just reviving this thread.

Do you know if the firmware stored in RAM instead of the drives?

Did you notice any improvement / deterioration in sound quality upon changing the drives?

Many thanks.

I made the change to Crucial MX500 SSDs in my N1ZH and felt there was a nice improvement.

I previously had an N1A and when I changed the drives the spinning disks just lifted out once the bolts were removed. On the N1ZH the spinning disks seemed to be attached on the rear side with a sticky pad as well as the bolts. Gentle pulling removed the spinning drives.

The change is very straightforward