Need help please !

[Plamenko]

Hi ! I need help how to instal MinimServer for Melco? I try to instal software following instructions and I couldn’t. Following instructions I downloaded software in my Mac(updated with last software). Than I try to instal on USB flash and I was following steps. When I try to activate software on Melco following instructions Melco did not recognise and did not start back up from USB flash ( error ). I did formatting on USB and try again downloading software on USB but it is not possible. Message “it is not USB drive”is coming. Try different USB flash memory but results was the same “it is not USB drive “. Please can you help me with installation process MinimServer for Melco ? My computer is MAC updated with last OS. Thank you in advance!

[simoncn]

I presume you are having the problem at this prompt:

Enter device identifier of Melco installer flash drive or null line to exit:

You need to enter something like disk1, disk2, disk3, .... depending on what is shown under the previous heading "The following USB drives are available".

Make sure you don't enter the wrong USB drive as this would destroy all data on that drive.

[Plamenko]

(14-11-2017 11:36)simoncn Wrote:  I presume you are having the problem at this prompt:

Enter device identifier of Melco installer flash drive or null line to exit:

You need to enter something like disk1, disk2, disk3, .... depending on what is shown under the previous heading "The following USB drives are available".

Make sure you don't enter the wrong USB drive as this would destroy all data on that drive.

Thank you for responding.When I try to instal program from hard drive of my Mac first time I enter disk 1 following process and it was looking like process is successful but Melco didn’t recognise and didn’t back up from flash memory(error 12). Then I try many times to repeat process and despite I was trying different options like disk0 disk 1 ( only those two are possible) and different USB drive but result is only: it is not USB flash? So I am stuck at this point. Maybe I have to uninstall and then reinstall program but I don’t now how to do this? Any advice?

[simoncn]

The create-installer wizard shows you the list of valid USB devices before prompting you to enter the device name. Please post this output from your system. As an example, on my Mac the output looks like this:

Code:

This utility writes the MinimServer installer image for the Melco N1 to
a USB flash drive. For this, you need to have a USB flash drive of 128 MB
or larger attached to this machine.

Check for available USB drives (y/n)?
y

The following USB drives are available:

   Device Identifier:        disk1
   Device / Media Name:      SanDisk Ultra USB 3.0 Media
   0:     FDisk_partition_scheme                        *15.4 GB    disk1
   1:                 DOS_FAT_32 MINIMSETUP              128.0 MB   disk1s1

Enter device identifier of Melco installer flash drive or null line to exit: