Issue with Lumin Control Point seeing Library

[Roy Boy]

(03-05-2014 08:35)simoncn Wrote:  

(02-05-2014 22:39)Roy Boy Wrote:  So my question is what might be the cause of the control point not seeing the library? I am not sure how to troubleshoot this. Thanks

It sounds like this is a network multicast discovery issue. You can confirm that MinimServer is running by checking the status web page at http://192.168.1.x:9790 where 192.168.1.x is the IP address of the NAS. The tagging messages wouldn't prevent MinimServer from running and being discovered by a control point.

Try powering off all your equipment (router, NAS, LUMIN, iPad) and then power it on in this order:

1) Router (wait 3 minutes for startup to coimplete)
2) NAS (wait 3 minutes for startup to coimplete)
3) LUMIN
4) iPad

I checked the status of Minimserver and it was running....I powered down and back up in the recommended sequence.. Unfortunately this did not change anything. The Lumin app still cannot see the library. I tried Kinsky app and had the same result. I also tried the Lumin app on a different IPAD with the same result...I did verify that Minimserver was running after the power up sequence....Very puzzling...