Issue with Lumin Control Point seeing Library

[simoncn]

(02-05-2014 22:39)Roy Boy Wrote:  So my question is what might be the cause of the control point not seeing the library? I am not sure how to troubleshoot this. Thanks

It sounds like this is a network multicast discovery issue. You can confirm that MinimServer is running by checking the status web page at http://192.168.1.x:9790 where 192.168.1.x is the IP address of the NAS. The tagging messages wouldn't prevent MinimServer from running and being discovered by a control point.

Try powering off all your equipment (router, NAS, LUMIN, iPad) and then power it on in this order:

1) Router (wait 3 minutes for startup to coimplete)
2) NAS (wait 3 minutes for startup to coimplete)
3) LUMIN
4) iPad