The control app thread

[jdg072]

(14-05-2025 09:18)simbun Wrote:  

(14-05-2025 07:32)jdg072 Wrote:  

(13-05-2025 13:55)simbun Wrote:  What renderer (streamer/speaker) are you using?

- I use a qnap which runs minimserver
- I use my android phone with hificast to control (I wish I could use 3 other phones to do the same in the family)
- I use my Hifiset to play the audio: a Denon AVR X2600H

which one is the renderer?

The UPnP Server is MinimServer, the Control Point is Hi-Fi Cast and the Renderer is the X2600H.

Denon don't implement the OpenHome extension so you'll need to install BubbleUPnP Server and use the BubbleUPnP Android app in order to control the playback queue from multiple devices.

Before installing BubbleUPnP Server try the Android app to make sure it works for you.

The interface of the BubbleUPnP Android app can be a little busy in its default configuration, but it's very customisable. I had posted some notes about how to configure it for just UPnP playback, so if you have any issues let me know and I'll dig them out.

Thank you. I know the bubble app a little, but BubbleUPnP Server qpkg did not have a valid signature, meaning QNAP doesn't trust this software. Should I allow it?
So after this all is set up, multiple people can stream also different qnap files through Bubbleupnp app to different renderes (radio's) too, or only see the same playlist?