Configuration

[simoncn]

If you click Configure in MinimWatch for a new MinimServer installation, you should see the following web pages in this order:

1) A "MinimServer License terms" page. To move to the next page, select "I accept" and click the Confirm button.

2) The MinimServer 2.2 welcome page. To move to the next page, click the OK button. If you don't want to see this page again, select "Don't show this page again" before clicking OK.

3) The MinimServer configuration home page. This page has 5 tabs: Status, License, Properties, Profiles and MinimStreamer. The Status tab is selected initially. If you have a full license, select the License tab and follow the prompts to activate your license on this device (your Melco N5). From your post, it sounds like you have already done this.

4) To set up your MinimServer configuration property settings, select the Properties tab. Under this tab there are three subtabs named Server, Advanced and System. Make any changes to the default property settings shown on these subtabs and click Save and Restart as needed.

5) If you want to use the optional MinimStreamer extension, select the MinimStreamer tab and click the Install button, then click OK from the pop-up. MinimStreamer will be installed and MinimServer will relaunch and take you to the About subtab of the MinimStreamer tab. To configure MinimStreamer, select the Properties subtab of the MinimStreamer tab and enter your MinimStreamer configuration property settings. If you don't want to use MinimStreamer at present, omit this step.