Minimserver on QNAP TS-109 not visible on network

[simoncn]

(25-08-2013 10:44)john_theobald@hotmail.com Wrote:  I have the same problem. I have attached the diag file if somebody would be so kind to look at.

Thanks.

This file shows that MinimServer was in the process of starting normally when it was stopped by an external command. It was stopped about 2 minutes 40 seconds after it was started.

Please try this again and wait at least 30 minutes for the startup to complete. The first startup is slower than usual because it needs to read every file in your library. After this, startup will be faster because MinimServer is reading file data from a cache.

It would also be helpful if you could install MinimWatch on a PC or Mac and use the Verbose logging level in the log window to monitor startup progress. This will show all the directories that are being scanned as part of the startup process, and will give you an indication in real time of how the startup scan is progressing.