Melco playlist problems

[Uktrumpetman]

(14-02-2022 16:48)simoncn Wrote:  I have looked at how Kazoo strores playlists and I think this is caused by your Melco changing its IP address since your created your playlists. This can happen from time to time because of the way your router assigns IP addresses to other devices on your local network. Your playlists are still there but they will not work until you set the IP address of your Melco back to what it was when the playlists were created. If you use Twonky instead of MinimServer, you will have the same problem if the IP adddress of your Melco changes.

To find the IP address that your playlists are using, open a playlist that isn't working. Touch and hold one of the tracks, then touch the "3 dots" icon and select Info. At the start of the line named Uri: you should see something like http://192.168.0.23:9790/minimserver/..... This would mean the IP address you need to select for your Melco is 192.168.0.23. This address will be different for you. Make a note of the address you see so that you can use it in the following instructions.

Now go to the front panel of your Melco and select Settings > Network > LAN Port. Change the selection from DHCP to Fixed IP. This shows a screen named IP Address. Use the arrow and enter keys to change the four numbers shown here to the IP address you found in the playlist. You will then see three more screens named Subnet Mask, Default Gateway and DNS Server. Click through these without changing anything. After this, the front panel will show "Please wait" followed by "Finished". Click OK and your playlists should be working.

You should now leave the Melco on Fixed IP to prevent this happening again. The only time this might change back to DHCP is if you do an Initialize Settings.

Thanks Simon, spot on, all sorted now.... Maybe put your solution in a FAQ on your forum?
Cheers