Profile Name visible in Watch Properties ?

[golke53]

(01-02-2021 12:10)simoncn Wrote:  On your iPad, use a web browser to open the page x.x.x.x:9790 where x.x.x.x is the IP address of your NAS. This opens the MinimServer configuration web page for your NAS from which you can view and change your active profile.

Your PC and MinimWatch are needed only to change property settings in a profile. This should be relatively infrequent. All other actions related to profiles (including viewing property settings) can be done from your iPad as explained above.

When the configuration web page supports changing property settings, all actions related to profiles will be possible from your iPad.

Very good suggestions, Simon. Using a browser with the IP and port# is relatively comfortable if you use a bookmark, which is relatively comfortable if you reserve a fix IP address for the NAS. Since I have done all this it works fine and I am happy with it. Why did I happen to arrive at the Minimserver Config page directly without any logon/password? Is that normal?

Your plans to integrate properties into the web interface creates desire and expectations. I am looking forward.