Announcing MinimServer 2 for QNAP

[simoncn]

(28-04-2020 21:14)golke53 Wrote:  That is all ok and understood, Simon. And I would appreciate to get a kind of notification from you before you lock a thread down while I was editing some additional information. In the end I was happy that Peter wrote to me so I knew that something was going on. Otherwise I would have been pretty upset tbh. Me sitting with a problem, you closing the thread with no communication to me left me in limbo. I have lost the properties due to my blindflight repair actions. So I am pretty upset tbh.

I have not locked or closed any threads. I see that the other thread where you reported the problem is locked but I did not do this.

I try to respond to problem reports as soon as possible but I cannot be on the forum 24/7.

I don't have every QNAP model and firmware level available here for testing. I do as much testing as I can before a release but there is always a possibility that a user with a different hardware platform or QTS version might encounter a problem.

Are you sure that you have lost your previous property settings? The MinimServer 2 installer should have copied them to the new 'MinimServer' shared folder before the crash. Uninstalling MinimServer 2 or MinimServer 0.8 does not remove your property settings from this new location. After installing MinimServer 2, your previous settings do not show up in MinimWatch 2 until you activate either a trial license or a full license.

If you have lost your property settings, I am sorry for the inconvenience of needing to re-enter them.