MinimServer Forum / MinimServer / MinimServer 2 v / Seemingly Serious Problem Updating to MS2 v2.0.6 in Melco N1Z/1 [SOLVED!]

Post Reply 
Seemingly Serious Problem Updating to MS2 v2.0.6 in Melco N1Z/1 [SOLVED!]
27-02-2020, 02:15 (This post was last modified: 27-02-2020 02:30 by GreenMtnGringo.)
Post: #14
GreenMtnGringo Offline
Member
***
 		Posts: 192
Joined: Dec 2016
Reputation: 1
RE: Seemingly Serious Problem Updating to MS2 v2.0.6 in Melco N1Z/1
Forty-five minutes and counting on this second attempt to install v2.0.6, the Melco display still shows, "Install in progress... Please wait..."

I am going to bail out of this endless installation loop by powering down the Melco (e.g., by pulling the AC power cord out of the back ... again).

Simon, I hope a solution can be found. If not, I may have to roll back to v0.8. Thanks.
Melco HA-N1ZH60 Mk1 (MinimServer 2.2) → USB → Luxman D-07X Black Edition Centennial SACD Player/DAC → XLR → Mark Levinson No. 523 → RCA → JL Audio E-Sub e110 (active crossover @ 100 Hz) → RCA → Bryston 4B3 (Cubed) → Magnepan .7
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Seemingly Serious Problem Updating to MS2 v2.0.6 in Melco N1Z/1 - GreenMtnGringo - 27-02-2020 02:15

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | MinimServer Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication