Unable to install with Melco N1

[pdcman]

(05-01-2019 20:38)simoncn Wrote:  If it takes a long time for MinimServer to get up and running, this is probably because you are running Twonky on the Melco as well. Twonky consumes a lot of CPU resources and this makes MinimServer run more slowly, especially on initial startup. The MinimServer install instructions tell you how to disable Twonky.

The username/password issue is caused by the 3.90 firmware. You can access your library by entering nobody/nobody for the username and password.

ah ah! Brilliant, thanks for your support Simon, I can now see it. Its annoying when they change these things in melco updates!

I'll look at turning twonky off when I've managed to change the trees in minimserver. that's my task for tomorrow. I might be back again..............!