Melco new firmware

[simoncn]

In a situation like this, I have found that the best approach is to first strip down to a minimal setup that works and then extend from there to my full configuration.

For the minimal setup, you could eliminate the Asus EA-N66 and use a long Ethernet cable instead. Alternatively, you could temporarily move other equipment to be near your router.

I think you are using the Melco as both a server and a renderer, presumably with a DAC attached to the Melco via USB. If this is correct, the minimal setup would be just the Melco attached to the router by an Ethernet cable and your control point communicating with the router via wireless.

If you can get the minimal setup working properly, you can add more equipment from there, one step at a time and retesting at each step. If any step of adding something causes a problem, you know that it is the something that you just added that is the cause of the problem.