Melco new firmware

[Rodders]

(18-01-2018 17:44)simoncn Wrote:  It sounds like you have a network multicast discovery problem. See this section for some suggestions for how to solve this.

BubbleUPnP supports mode 1. Have you tried this?

I've changed mode to 1. I've also checked router (Zyxel VMG8924-B10A) settings. Enhance Multicast forwarding was off in Broadband settings, so I've tried turning this on. I've also disabled IGMP snooping. So far it's not made any difference.

Note that BubbleUPnP has always taken 6 to 9 minutes before Melco appears in Renderer listing whereas in Kazoo it would appear almost instantly. Now it doesn't see Melco at all.