Control point cant see minimserver

[Klaus57]

(27-12-2016 16:31)Klaus57 Wrote:  

(27-12-2016 16:23)DavidHB Wrote:  

(27-12-2016 12:02)Klaus57 Wrote:  I have the same situation; I use Lightning DS as Control Point and the Auralic streaming bridge. NAS: QNAP HS210 and HS 251 - both running the newest Firmware.

This sounds like a network discovery issue. The update may indeed have triggered some sort of change or the issue may have been coincidental, but the problem is unlikely to lie with MinimServer as such (if it did, there'd be a lot more people complaining!)

In the circumstances you describe, my immediate suspicion would be directed at the one system component you don't mention - your router, and specifically its multicast settings. These are differently arranged and accessed on each router model, so it is very difficult to give specific advice. You might try powering down the whole system, and them powering it back up progressively, starting with the router. Let each component boot fully before starting the next one. This approach can sometimes clear network glitches.

David

Thanks for your advice. I will follow your Recommendations.

Klaus

For several days everything seems to be ok. There were some router default settings in combination with running two minimserver which probably caused the troubles. Minimserver was not the reason.
Klaus