Melco Audiophile NAS

[simoncn]

When you power on the N1, the following happens:

1) Twonky starts and shows up in the control point
2) Twonky begins a complete rescan of the library
3) MinimServer starts and begins a complete rescan of the library
4) When the MinimServer rescan completes, MinimServer shows up in the control point

With a large library, step 3 takes a long time because step 2 is consuming a lot of CPU resource and doing a lot of disk I/O to the same files and this makes MinimServer run much more slowly than normal.

The only solution at present is to set the MinimServer startupScan property to false. This omits step 3.