Melco Audiophile NAS

[Playback]

Melco just released a Notification regarding the latest 3.1 firmware.
They advise everyone who upgraded (like me) to revert back to firmware 3.00 because of problems with the new 3.10 firmware.

Announcement here: http://www.melco-audio.com/

To revert back to firmware 3.00 please follow the following steps:

Installing MinimServer on the Melco N1 (reverting back to v. 3.00)

V3.00 can be set through Network or USB.

To set N1 FW as V3.00 by USB...

1 -- Take an empty USB Stick.
2 -- On PC or Mac go to
http://buffalo.jp/support_s/guide2/manua...anual.html
and download V3.00 FW.
* Please un-tick the box 'Show only latest'

3 - Unzip the file to the USB stick
4 – Inset USB stick into N1 USB3 port at rear
5 – N1 may ask ‘Import Music..' Use BACK button as this is not what is required
6 – MAIN MENU – 5 SYSTEM UPDATE – 2 USB – press OK. There will be message all settings will be lost as older version of FW. Press OK
7 – N1 will power cycle when complete and USB stick can be removed
8 – Set LANGUAGE, TIMEZONE and POWER SAVE.
9 – Check the installed FW version - MAIN MENU – 1 STATUS -- 7 SYSTEM SOFTWARE - Should report as V3.00

Note: In the end, because you've downgraded the N1 firmware to an older level, you'll need to do a full installation of minimserver again.