Threaded Mode | Linear Mode

rich28 · 18-03-2016, 13:05

(17-03-2016 21:50)simoncn Wrote:
(17-03-2016 20:22)rich28 Wrote: Apologises, I've got myself into pickle and by the sounds of it haven't been clear. When I first raised this issue I mentioned that using the *:wav setting the BBC HLS streams worked for one of my UPnP renderers, a Libratone wireless speaker, but not the other, my Pi running Moode Audio. Subsequent to that in one of my posts I mentioned that I had managed to get BBC HLS streams working on Pi using the *:wav16;44 setting , which as it transpires was a mistake - I can't get BBC HLS streams to playback to the Pi using this setting.

Hence, as it stands my Pi isn't playing ball with either *:wav or *:wav16;44. I have restarted BubbleUPnP Server, the control point and the pi, but this doesn't change anything.

However, if I assign *:mp3;320k to stream.transcode I can get BBC HLS streams to playback on both of my renderers, the Pi and my Libratone wireless speaker and I'm therefore going to stick with that setting

Thanks for clarifying. I have the same setup except for Kinsky instead of Kazoo and no BubbleUPnP Server. All transcoding settings are working for me. It might be worth asking about this on the BubbleUPnP forum.

OK, thanks for getting back to me. I will try to raise this issue with BubbleUPnP. Incidentally, I will add that after a short pause my pi does stream BBC HLS content using both the L16 and L24 settings. However, Moode Audio informs that in both causes the source is only mono and the rate is low, at best 160kbs. And neither of these settings work for my Libratone speaker, though perhaps this may be due to the fact that its an DNLA certified/airplay device which I suspect will impose limitations of it acting as a UPnP renderer.