MinimServer 0.8.2 update 40 temporarily shows error message

[simoncn]

(01-09-2014 17:49)DavidHB Wrote:  On applying update 40 to the MinimServer installation on my ReadyNAS, error messages were generated, as shown in the following log sequence:

As can be seen, restarting seems to have removed 2 of the 3 error messages, and then the third message did not appear after a rescan. So the problem seems to be resolved. Do the error messages have any particular significance?

My Windows installation of MinimServer did not produce any errors when update 40 was applied.

David

Thanks for letting me know about this.

Which update level was installed on the ReadyNAS before you applied update 40?

Which control point are you using?