Help installing ffmpeg
|
22-09-2018, 13:41
Post: #1
|
|||
|
|||
Help installing ffmpeg
Hi,
I installed ffmpeg according to the instructions in MinimStreamer guide but it is not recognized and I cannot use 'stream.transcode' options. I keep on getting 'converter not installed'. What I am doing wrong ? Thanks. |
|||
22-09-2018, 15:34
Post: #2
|
|||
|
|||
RE: Help installing ffmpeg
I think you may need to make the ffmpeg executable and give execute permission for it (depending on users and what you are running it on)
|
|||
22-09-2018, 19:03
Post: #3
|
|||
|
|||
RE: Help installing ffmpeg
What machine are you using to run MinimStreamer and install ffmpeg?
|
|||
22-09-2018, 20:46
Post: #4
|
|||
|
|||
RE: Help installing ffmpeg | |||
22-09-2018, 21:23
(This post was last modified: 22-09-2018 21:23 by simoncn.)
Post: #5
|
|||
|
|||
RE: Help installing ffmpeg
Did you power the Melco off and on after copying ffmpeg to opt/bin, as described in the last paragraph of this section?
|
|||
22-09-2018, 22:16
Post: #6
|
|||
|
|||
RE: Help installing ffmpeg
(22-09-2018 21:23)simoncn Wrote: Did you power the Melco off and on after copying ffmpeg to opt/bin, as described in the last paragraph of this section? Yes I did. |
|||
23-09-2018, 08:54
Post: #7
|
|||
|
|||
RE: Help installing ffmpeg
(22-09-2018 22:16)amiglick Wrote:(22-09-2018 21:23)simoncn Wrote: Did you power the Melco off and on after copying ffmpeg to opt/bin, as described in the last paragraph of this section? Simon, My mistake, I installed the wrong version of ffmpeg. Then followed the NEW instructions "[NEW] You can download a suitable ffmpeg static binary from this page. For the Melco N1, you need the armhf build." and everything works perfectly ! Thank you! |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)