Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Minim on Melco N1
05-11-2018, 21:26
Post: #1
Minim on Melco N1
Hi, I've followed the instructions carefully but having fired back up (and having re-entered location/time etc) it didn't seem to download the minim server. It just just into its normal mode.

I then linked on to the N1 via my mac and found the attached message - saying expansion drive not found after 5 seconds.

What should I do now?
Thanks
Matt


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
05-11-2018, 23:00 (This post was last modified: 05-11-2018 23:03 by simoncn.)
Post: #2
RE: Minim on Melco N1
This is probably caused by not following step 6 of the instructions in this section. To complete the installation, power off the N1, insert the USB flash drive into the USB port marked Expansion, power on the N1 and continue from step 9.
Find all posts by this user
Quote this message in a reply
06-11-2018, 20:03
Post: #3
RE: Minim on Melco N1
Thanks. I have done it again (you were correct I hadn't put it in the expansion slot!)

But instead of downloading/scanning it went straight into its normal mode - unless it's doing something behind the scenes?

I attach a WeTransfer link (https://we.tl/t-yUDQrWhGs2) to an image showing the minimsetup.log file which says 'No MinimServer instances are running..' Also attach the MinimServer.log & MinimServer-out.log

Any idea what I've done wrong this time?
Find all posts by this user
Quote this message in a reply
06-11-2018, 23:16
Post: #4
RE: Minim on Melco N1
These logs show that MinimServer has installed successfully, has scanned your library and is running normally.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)