Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
minimstremer availability (Feb 2018)
19-02-2018, 13:47
Post: #1
minimstremer availability (Feb 2018)
Hi Folks,
today reinstalled Minimserver and minimwatch on Dell laptop.
Checked packages, it says 2 installed, none available:
minimserver-0.8-update-121 Active
minimserver-0.8.5.2 Active+original
The following packages are available for installation:
minimstreamer-0.7.6
OK ...so mscript says minimstreamer is available,
but install minimstreamer says:
Resource not available: http://jminim.com/packages/ minimstreamer.jmpkg
+:status=1
......Has it been removed now?
I wanted to activate the on-the-fly conversion to 192/24 on my Zen mini like before = noticeable improvement on Linn DSM.
Thanks a million - Nigel, Bahrain
Find all posts by this user
Quote this message in a reply
19-02-2018, 16:23
Post: #2
RE: minimstremer availability (Feb 2018)
There are two reasons for this:

1) You need to type install minimstreamer-0.7.6 instead of install minimstreamer

2) If you do the above, you will get a message 'Package license was not accepted.' This is because you are trying to use mscript to do the installation and mscript cannot prompt you to accept the MinimStreamer license. If you use startc instead of mscript, you will get the MinimStreamer license prompt and installation should be successful.

Note: startc will prompt you to do a relaunch to activate the new package but there is currently a problem with this. After typing the relaunch command and pressing Enter, you need to press Enter a second time to allow the relaunch to proceed. This will be fixed in the next MinimServer update.
Find all posts by this user
Quote this message in a reply
15-03-2018, 11:54
Post: #3
RE: minimstremer availability (Feb 2018)
(19-02-2018 16:23)simoncn Wrote:  Note: startc will prompt you to do a relaunch to activate the new package but there is currently a problem with this. After typing the relaunch command and pressing Enter, you need to press Enter a second time to allow the relaunch to proceed. This will be fixed in the next MinimServer update.

This problem with the relaunch command is now fixed in MinimServer update 122.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)